The pins will fall out to the back and you might lose them. Place the punch on the centre pin of the rivet and knock it out backwards out of the spreader rivet. To remove the spreader rivets you need a punch or screwdriver with a shaft not thicker than 4.5mm (Pins in the spreader rivets is 4.9mm). Also please note that my Tig has the “Off-Road” front.ĭifference between Off-Road front and normal front:Īfter you have removed the license plate you will see 5 spreader rivets. Some license plates are pop-riveted to the License Plate Holder and the rivets need to be drilled out. If you have any further questions about the Volkswagen Crafter, do not hesitate to consult our Volkswagen Crafter category.First start by removing the license plate from the license plate holder. If you need to change other bulbs like the position light bulbs on your Volkswagen Crafter or the low beam bulbs on Volkswagen Crafter, don’t hesitate to consult our articles which explain you the process to follow. If you can’t do it, don’t hesitate to go to your garage it would be a shame to break a part of your Volkswagen Crafter.
There you have it, you have learned the main techniques for changing license plate bulbs on your car, take note that on some models the methodology may be a bit different but you should be able to accomplish it following the explanation of this content.
Vw front license plate holder replace how to#
How to swap the rear license plate bulb on my Volkswagen Crafterįinally last possibility, you must swap the bulb on the backplate of your Volkswagen Crafter, but you cannot open the cover from the outside of your automobile. To swap the one on the front plate, nothing could be less difficult, you will have to position yourself under the automobile (preferably placed on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, usually held by two soft plastic tabs by pressing on both at once, then now that you have your license plate bulb block in hand, Take away the plastic that acts as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (take care not to exert too much force or you will break the plastic cover), and you will only have to take away the burnt-out license plate bulb and swap it with the new, then test out and reassemble the whole thing. How to swap the front license plate bulb on my Volkswagen Crafter
Vw front license plate holder replace series#
Generally you will be able to access it, however some series (often at the rear does not allow this access).
Second section of our article, swap this license plate bulb on your Volkswagen Crafter without external access. How to change the number plate bulb on your Volkswagen Crafter without outside access Last step, before reassembling, reconnect your battery and test the light to validate the successfulness of the procedure.Finally, position the new license plate light bulb.Use your screwdriver or knife to remove the bulb from its spot, in the event that you are scared of damaging a thing, you can as well do it with your fingers.Position yourself in front of your license plate and use a flat screwdriver or knife to insert the flat part into the notch provided for this intent (usually on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Volkswagen Crafter.With the engine turned off, disconnect the battery terminals from your car.Here are a few simple steps to stick to to execute this routine service: Regardless whether it’s the front or the back of your automobile the procedure will be the same. So let’s start with changing the number plate bulb by going through the outside of your Volkswagen Crafter. Sadly on some years or packages of car these covers do not open from the outside and if this is the situation we will take some time on in the second section of this content to teach you the approach. This option is the easiest of the two, in fact, for this one you will simply require to take away the protective covers of the bulbs.
0 kommentar(er)
